CHAPTER 2. MMC ProgrammingSamsung Business Communications 2-349236B[834] H.323 OPTIONSThis MMC provides various VoIP support options. The options set in this MMC applysystem wide. (This MMC is not shown in OfficeServ 7030)No Parameter Description Default00 GATEWAY CALL ID Numeric identifier for system(up to 12 digits) 123401 H.323 FAST SETUP Enables or disables the H.323 Fast Start call setupmethod.ENABLE02 CALLER ID TYPE This option controls the calling party identificationtype. There are 3 possible selections:0 GWID: shows the gateway call ID.1 ANI: shows the calling station number2 IP: shows the calling H.323 gateway IPaddress.ANI06 TUNNELING Enables or disables the need for additionalchannels using H.245 signalling. Tunneling allowsuse of the H.245 signal channel with the Q.931channel.ENABLE07 DEFAULT DIL NO This allows programming of the default direct-in-line number when digits are missing or incorrect onan inbound call.50011 CODEC AUTO NEGO Enables or disables Auto CODEC Negotiationwhen the MGI is used as an H.323 gateway.ON14 SIGNAL PORT Indicate the port number for H.323 signalling andsets a range of numbers allowed by firewallequipment. The common and default IP path orport used is 10000.1000017 SEND CLIP TABLE Refers to SEND CLI NUMBER(MMC 323), whichprovides calling party identification when using theMGI as a H.323 gateway. This provides station IDof the calling station. A single-digit valuecorresponding with the desired table in MMC 323should be entered here. This is only used whenMMC 405 value is null.118 INCOMING MODE This option selects how incoming calls are routedwhen the MGI is used as a H.323 gateway.0 FOLLOW TRUNK RING: Follows MMC 4061 FOLLOW DID TRANS: Follows MMC 7142 FOLLOW INCOM DGT: Follows MMC 724FOLLOWDID TRANS19 ALLOW GW CHECK When using a gatekeeper, this permits the H.323gateway to check for gatekeeper presence.DISABLE20 CLIR WITH NUMBER When this option is enabled, the CLIP number issent to the network even if the CLIP restriction flagis set.DISABLE21 USE OVERLAP DIAL Enables use of overlap dialing. ENBLOC