CHAPTER 2. MMC ProgrammingSamsung Business Communications 2-127113B[416] ASSIGN E & M/DID RINGDOWNThis MMC defines which ring destination table an E & M or DID trunk will followfor incoming calls. There are three options for each trunk as defined below.No Option Description0 FOLLOW INCOM DGT When a trunk is set to this option, calls will ring at thedestination that matches the digits received from the Trunk line.1 FOLLOW DID TRANS When a trunk is set to this option, calls will ring at thedestination defined in MMC 714 that matches the digitsreceived from the TRUNK LINE.2 FOLLOW TRK RING If this option is selected, press the Right Soft button and ‘NO.RCV DIGIT’ will appear on the display. Here is where thenumber of incoming digits from Trunk Line must be entered(0-4). When a trunk is set to this option, calls will ring at thedestination defined in MMC 406 for that trunk. If the destinationdefined in MMC 406 is a VMAA port or group then the systemwill repeat the digits received from the CO to the port when itanswers.554BCONDITIONSR2MFC trunk lines only support the ‘FOLLOW INCOM DGT’ and ‘FOLLOW DIDTRANS’ options.MMC [413]This MMC is not shown in OfficeServ 7100 / OfficeServ 7030. OfficeServ 7100 /OfficeServ 7030 does not support E1 trunk card.555BDEFAULT DATAFOLLOW INCOMING DIGIT556BACTION DISPLAY1) Press Transfer button and enter 416.Display shows:[U7U01] EM/DD RINGFOLLOW INCOM DGT2) Enter desired trunk number.(e.g., 705)OR[705] EM/DD RINGUFUOLLOW INCOM DGTPress Volume button to make selection andpress Right Soft button to move cursor.ORSelect all trunks.[ALL] EM/DD RINGUFUOLLOW INCOM DGT
