CHAPTER 2. MMC Programming2-252 Samsung Business Communications183B[724] DIAL NUMBERING PLANThis MMC allows the technician to change directory numbers for stations, trunks, stationgroups, trunk groups and feature access codes. The system can be pre-programmed withdefault 3- or 4-digit numbering for stations, station groups and trunk numbers dependingon the position of the DIP switches on the MCP card. There is an error message provided toprevent the accidental duplication of a directory number or feature access code.No Type of Dial No Description00 STN DIAL NO. This is where station directory numbers are changed or assigned.01 TRK DIAL NO. This is where trunk directory numbers are changed or assigned.03 MISC DIAL NO. This is where directory numbers for relays, MOH ports and thealarm sensor are changed or assigned.04 STNG DIALNUMBERThis is where station group numbers are changed or assigned.05 TRKG DIALNUMBERThis is where trunk group numbers are changed or assigned.06 FEAT DIAL NUMBER This is where feature access codes are changed or assigned. Dial-ling codes are entered via the dial keypad by pressing a numberthe required number of times to select the feature. For example, forOHVA, the number 6 would be pressed three times.Please remember that this program is system-wide.07 S0 STN DIAL NO. This is where directory numbers for BRI station ports are changedor assigned.09 NTWK LCR DIAL NO This is where additional LCR access codes are entered if two ormore OfficeServ 7000 Series systems are networked together.