CHAPTER 2. MMC Programming2-224 Samsung Business Communications168B[709] TOLL PASS CODE/SPECIAL CODE TABLEThis MMC provides a means to program trunk code tables as described below.No Special Code Description0 PBX ACCESS CODE This table contains up to five entries and is used to identify thetrunk access codes needed for toll restriction when the systemis used with either a PBX or a CENTREX-supplied dial tone. Tollrestriction will only be applied on trunks flagged as PBX in MMC401 if a trunk access code entered in this table is dialled. Tollrestriction will be applied to the digits following the trunk accesscode.1 SPECIAL CODE This table identifies the special feature codes used to activatecentral office custom-calling features such as CID Block andCall Waiting Disable. The special feature codes can be used ona per-call basis without affecting LCR or toll restrictionprogramming. There is a maximum of 10 entries available, eachof which may be up to four digits long.2 TOLL OVERRIDE This table of eight entries is used to identify the numbers thatwill bypass all dialling restrictions. This bypass includes tollrestriction, trunk access and forced authorization or accountcodes. Each entry in the table can be up to 14 digits long.3 OVRD USE TRK GRP This entry designates the trunk group that toll override calls willaccess.744BDEFAULT DATANONE745BACTION DISPLAY1) Press Transfer button and enter 709.Display shows:PBX ACCESS CODE1:2) Select PBX, SPECIAL CODE, TOLL OVERRIDEor OVRD USE TRK GRP.TOLL OVERRIDE1:ORPress Volume button to make selection andpress Right Soft button to move cursor.3) Enter index number.(e.g., 3)ORTOLL OVERRIDE3:_Press Volume button to make selection andpress Right Soft button to move cursor.