CHAPTER 2. MMC ProgrammingSamsung Business Communications 2-131116B[419] BRI OPTIONSAssigns several options on a per-BRI basis. There are different options depending onwhether the BRI is programmed as a trunk or station in MMC 423.1068BOPTIONS FOR BRI PORTS PROGRAMMED AS TRUNKSNo Option Description0 CHANNEL ANY When this option is set to YES, the system will place calls on any freechannel of that BRI if the channel chosen by the user is busy. If set toNO, they will receive a busy signal if they attempt to access a busychannel even if the other channel on that BRI is free.1 BRI MODE BRI access mode select.P-P NOR Point to Point NORmal. This operates like a standard telephone line withone CO number per channel and ring according to MMC 406.P-P DID Point to Point Direct Inward Dial. This operates in a similar manner to ananalogue DID circuit with multiple CO numbers pointed to a singlechannel and translated within the system(MMC714) to a single device.P-M NOR Point to Multi-point Normal. This type of circuit operates in a similarmanner to P-P NORmal but allows multiple devices to be attached to thecircuit. Ringing is defined in MMC 406.P-M MSN Point to Multi-point MSN. This setting is used when the line uses theMSN supplementary service. Ringing is defined in MMC 421.2 DLSEND BRI dial sending mode select.ENBLOCK Digits will be collected and sent in a single block similar to a Cellphone.OVERLAP Digits will be sent as they are dialled by the user.3 CLIP TABLE Used to select the Calling Party Number to send to the network. IfNONE, MMC405 TRUNK CO TEL NUMBER is sent to the network;otherwise, the Calling Party Number entry in MMC 323 correspondingwith the selected number is sent to the network.4 NB TYPE Used to select the type of the Calling Party Number to send to thenetwork.UNKNOWN Unknown numberINT.NAT International numberNATIONAL National numberNETWORK Network specific numberSUBSCRIB Subscriber numberABBREV Abbreviated numberEXTEN Local number