CHAPTER 2. MMC ProgrammingSamsung Business Communications 2-381(continued)No Parameter Description Default07 VERSION WLAN module version. Version10 WBS TX PWR TX POWER of all WBSs.If AP type is not Commercial AP, this option can be shown.DEFAULT19 CLR WBSREG Initializes registration data of all WBSs.If AP type is not Commercial AP, this option can be shown.NO20 MAX AP CH. Set the maximum channel number of APIf AP type is not Commercial AP, this option can be shown.0021 WLAN SWTCH Support WLAN switch functionIn case that AP type is not WBS COMBO, this option canbe shownDISABLE22 DELETE SIP Select whether SIP Protocol will be used or not adaptingWLAN phone.DISABLE1100BWBS PARAMETERThere are two types of WBS, the COMBO AP and BASIC AP. A system cannot use bothtypes of WBS at the same time. The AP type to be used can be set in MMC 849. Dependingon the selected AP type, this program displays COMBO AP(CWBS), and BASIC AP(BWBS).y When using COMBO AP(CWBS)WBS24 COMBO is connected to a WLI card. Up to three WLI cards can be installed.(A single WLI card can connect up to eight WBS24 COMBOs.)y When using BASIC AP(BWBS)WBS24 BASIC is connected to the system through the network and requires an MGIport to provide tone and call path connection.No Parameter Description Default00 IP ADDRESS WBS24 IP address for Ethernet. 0.0.0.001 GATEWAY Gateway address of the WBS24 Network. 0.0.0.002 NET MASK Netmask of the WBS24 Network. 255.255.255.003 MAC ADDR MAC address of WBS24 received by the systemwhen WBS24 is connected.FFFF FFFF FFFF04 VERSION WBS24 software version. Version05 STATUS Alive operation status. OFF06 RF CH. RF channel no. used by each WBS24. 1, 6, or 1107 TX POWER TX POWER of each WBS. DEFAULT09 TIME ZONES Time zone service for each WBS 00:0010 PARA CLR Initializes WBS registration data. NOWBS NAME It is available to enter the name corresponding toeach WBS. Maximum 11 characters can be en-NONE
