Interrupting a Copy RunXerox WorkCentre C226 User Guide 2-77Interrupting a Copy RunINTERRUPT can be used to temporarily stop a long copy run so that another copy jobcan be run.It is not possible to interrupt an automatic two-sided copy job.1. Touch the [INTERRUPT] key.If the [INTERRUPT] key does not appear, interrupt copy-ing is not possible.When the [INTERRUPT] key is touched in step 1, the[INTERRUPT] touch key will be replaced by the [CAN-CEL] key as shown in the illustration.NOTES: • If you touch the [INTERRUPT] key when the account counter function is turned on,the display will prompt you to enter your account number. Enter your accountnumber with the numeric keys. The copies you make will be added to the count ofthe entered account number.• If the [INTERRUPT] key is touched while an original is being scanned, theinterrupt state will begin after scanning is completed. If the [INTERRUPT] key istouched during copying, the interrupt state will begin after the copy is completed.• Interrupt copying is not possible during automatic two-sided copying using theoptional Duplex Module/2-Tray Unit. In addition, automatic two-sided copying isnot possible during interrupt copying.2. Place the original for the interrupt copy job in the DADF or on the document glass(pages 2-4 to 2-10).If a black and white copy job is being interrupted to runanother black and white copy job, the number of origi-nals that can be copied in the interrupt job is 35. (basedon text original (A) on page 2-17)Cancel
