Programming Frequently Used OperationsXerox WorkCentre C226 User Guide 5-45The following settings can be stored in a program:• Destination fax number• Polling• Dual Page Scan• Resolution and exposureAuto-dial keys (one-touch or group keys) are used to store the destination fax number.A full number cannot be entered using the numeric keys. When storing a broadcasttransmission or serial polling operation in a program, up to 100 destination fax num-bers can be stored.NOTES: • A program differs from a timer transmission in that it is not cleared from memoryafter transmission takes place. A program thus allows you to repeatedly performthe same type of transmission. Note, however, that programs do not allow you toestablish a timer setting for transmission.• With the exception of polling, reception operations cannot be stored in a program.Using a Program1. In fax mode, load the document.Do not load a document if you are performing a pollingoperation.If you are going to use Dual Page Scan, place the docu-ment on the document glass.2. Touch the [SPECIAL MODES] key and then the [PROGRAM] key.If the address directory screen appears, touch the [CON-DITION SETTINGS] key to display the condition settingsscreen.3. Touch the program key you wish to execute. Make sure the key is highlighted andthen touch the [OK] key.The program key you touched is selected and you returnto the screen of step 2.The [PROGRAM] key is highlighted./PollingProgramDual PageScanAddress ReviewSpecial Modesg.ram1Ok
