1-70 Xerox WorkCentre C226 User GuideGeneral Information15. Push the Saddle Stitch Finisher back against the main unit.Troubleshooting Saddle Stitch Finisher problemsCheck the list below before calling for service.Problem Check Solution or causeStapling position isnot correct (includ-ing saddle stitch).Stapling position not set properly? Check the stapling position setting. (Seepages 1-72 and 1-73.)The Saddle StitchFinisher does notoperate.Are any Saddle Stitch Finisher coversopen?Close all covers. (See pages 1-68 and 1-69.)Message indicating need to removepaper from the stapler compiler dis-played?Remove all remaining paper from thestapler compiler referring to step 4 onpage 1-63.Stapling cannot beperformed (includ-ing saddle stitch).Message to check the staple unit dis-played?Remove jammed staples. (See page 1-63.)Message to add staples displayed? Replace the staple cartridge. (Seepage 1-61.) Check that a staple cartridgehas been installed. (See page 1-61.)Different size paper included? Stapling cannot be performed onto differ-ent size paper.Is the paper badly curled, preventing sta-pling?Differences in paper quality and typemay result in bad curling of output paper.Take the paper out of the tray or BypassTray, turn it around, and reload it so thatthe top and bottom edges are reversed.The punch holepositions are notcorrect* 1The punch function is not set to the cor-rect punch positions.Check the allowed hole punch positions.
