Xerox apeosport 550 I Network Administration Manual

Contents

Xerox apeosport 550 I Network Administration Manual Manual pdf 104 page image

12 Using Scan Service102Using Scan Service123 Set an IP address.If an IP address is already set, this step is not necessary. Also, in an environment withDHCP or BOOTP, configure the way to obtain an IP address. Either the addresscannot be obtained automatically or manual configuration is preferred, configure an IPaddress, a subnet mask, and a gateway address.1) Select [Protocol Settings].2) Select [TCP/IP - Get IP Address] and then select [Change Settings].3) Select one from [DHCP], [BOOTP], [RARP], [DHCP/Autonet] or [Manual] and thenselect [Save]. If you select anything other than [Manual], proceed to Step 4.Note • When using a DHCP server, also configure the WINS (Windows Internet Name Service)server.4) Select [TCP/IP - IP Address] and select [Change Settings].5) Enter the IP address using the numeric keypad.Note • Enter the address in the format “xxx.xxx.xxx.xxx”. The "xxx" should be a numeric value in therange from 0 to 255. However, 224 or 225.xxx.xxx.xxx and 127.xxx.xxx.xxx cannot be used.• When you make an entry mistake, press the (Clear) button and enter again.• When moving to the next value without entering all 3 digits, select [Next].6) Select [Save].7) Configure [TCP/IP - Subnet Mask] and [TCP/IP - Gateway Address] as the above.Note • Enter the address in the format “xxx.xxx.xxx.xxx”. The "xxx" should be a numeric value in therange from 0 to 255. However, 224 or 225.xxx.xxx.xxx and 127.xxx.xxx.xxx cannot be used.• Specify the subnet mask by a combination of the numbers 0, 128, 192, 224, 240, 248, 252,254, and 255. However, you cannot use 0 between non-zero values.• If you do not set the gateway address, enter "0.0.0.0".4 Select [Close] repeatedly until the [System Settings] screen is displayed.5 Select [Exit].6 After the machine is restarted, print out a settings list to confirm that the mail send portis enabled and TCP/IP is configured.For information on how to print a settings list, refer to "Print Report/List" under "Chapter 13 MachineStatus" in the User Guide.Configuring E-mail EnvironmentThe following describes the configuration procedure to use the E-mail feature.Note • The configuration can also be performed using CentreWare Internet Services.For information on how to use CentreWare Internet Services, refer to "Using CentreWare InternetServices" (P.65).1 Display the [System Administrator Menu] screen.1) Press the button.2) Enter the user ID with the numeric keypad or a keyboard displayed by pressing[Keyboard], and select [Confirm].Note • The default user ID is “11111”. When using the Authentication feature, a password isrequired. The default password is “x-admin”.3) Select [System Settings].