Configuration of Scan to FTP/SMB115Using Scan Service12Enabling Port and Setting TCP/IPIn order to use Scan to FTP/SMB, enable a port (SMB or FTP client) and set the IPaddress. The procedure for setting the machine is as follows.Note • The configuration can also be performed using CentreWare Internet Services.For information on how to use CentreWare Internet Services, refer to "Using CentreWare InternetServices" (P.65).1 Display the [System Administrator Menu] screen.1) Press the button.2) Enter the user ID using the numeric keypad or a keyboard displayed by pressing[Keyboard], and select [Confirm].Note • The default user ID is “11111”. When using the Authentication feature, a password isrequired. The default password is “x-admin”.3) Select [System Settings].2 When using the SMB protocol, enable the SMB port.1) Select [System Settings].2) Select [Network Settings].3) Select [Port Settings].4) Select [SMB] and then select [Change Settings].5) Select [Port Status] and then select [Change Settings].6) Select [Enabled] then select [Save].7) Select [Close] repeatedly until the [port Settings] screen is displayed.3 When using the FTP protocol, enable the FTP client port.1) Select [FTP Client] and then select [Change Settings].2) Select [Port Status] and then select [Change Settings].3) Select [Enabled] then select [Save].4) Select [Close] repeatedly until the [Network Settings] screen is displayed.4 Set an IP address.If an IP address is already set, this step is not necessary. Also, in an environment withDHCP or BOOTP, configure the way to obtain an IP address. Either the addresscannot be obtained automatically or manual configuration is preferred, configure an IPaddress, a subnet mask, and a gateway address.1) Select [Protocol Settings].2) Select [TCP/IP - Get IP Address] and then select [Change Settings].3) Select one from [DHCP], [BOOTP], [RARP], [DHCP/Autonet] or [Manual], and thenselect [Save]. If you select anything other than [Manual], proceed to Step 5.Note • When using a DHCP server, also configure the WINS (Windows Internet Name Service)server.4) Select [TCP/IP - IP Address] and then [Change Settings].5) Enter the IP address using the numeric keypad.Note • Enter the address in the format “xxx.xxx.xxx.xxx”. The "xxx" should be a numeric value in therange from 0 to 255. However, 224 or 225.xxx.xxx.xxx and 127.xxx.xxx.xxx cannot be used.• When you make an entry mistake, press the (Clear) button and enter again.• When moving to the next value without entering all 3 digits, select [Next].6) Select [Save].
