Xerox apeosport 550 I Network Administration Manual

Contents

Xerox apeosport 550 I Network Administration Manual Manual pdf 52 page image

6 Installation When Using NetWare50Installation When Using NetWare6PreparationsPrepare the following items to install the machine when using a NetWare network.z NetWare serverz TCP/IP or IPX/SPX network environmentz CentreWare Utilities CD-ROM (provided with the machine)Installation ProcedureInstallation OverviewThe machine supports a PServer mode both for the NetWare Directory Service andBindery Service. The PServer mode enables the machine to function as a print serverand to capture print jobs in the print queue to output. The printer created for themachine consumes one file server license.Note • The machine does not support a Remote Printer (RPrinter) mode.• You can use the machine as a printer in a NDPS environment by using a Novell NDPSGateway. When using in a NDPS environment, settings of the machine to be used under aNetWare print environment are required. Or, you need to enable LPD in advance and set itas a gateway destination in a Novell NDPS Gateway setup. However, attribute informationthat can be set or captured by NDPS is not supported.Supported interfacesz 100BASE-TXz 10BASE-TSupported frame typesz Ethernet II specificationz IEEE802.3 specificationz IEEE802.3 / IEEE802.2 specificationz IEEE802.3 / IEEE802.2 / SNAP specificationNote • The machine will send packets of each frame type on the network, and will initialize for thesame frame type as the first reply packet received. You can fix a flame type in use. However,if there are multiple protocols running on the same network, use Ethernet II specification.• Some network equipment (hubs, etc.) may not support the automatic frame type detection. Ifa data link indicator corresponding to the port of the network equipment connected with themachine does not light up, change the settings of the frame type of the machine to the frametype of the file server. Configuration can also be performed using CentreWare InternetServices.The following describes the configuration procedure to connect the machine to aNetWare network.z Configuration on the Machine- To use IPX/SPX, the machine is configured using the CentreWare Utilities CD-ROM after enabling the NetWare port of the machine.- To use a LPD port in NDPS, the machine is configured using the CentreWareUtilities CD-ROM after enabling the LPD port of the machine and setting TCP/IP.z Configuration on the computerInstalling a print driver.