Installation Procedure39Installation When Using Parallel Port34 Configure the following items as necessary.z Print ModeConfigure the print language on the machine to match the received data.z PJLEnable when receiving a job using PJL commands.The PJL commands are independent of any print languages. A print language usedin the next data can be set independently of the current print language.z Auto Eject TimeConfigure the time that the data so far received by the machine will automatically beprinted since data is no longer sent to the printer.z Adobe Communication ProtocolConfigure the protocol defining the communication method between PostScriptprinters and a host.z Bi-directional CommunicationConfigure the parallel port for either half duplex transmission or full duplextransmission.z Input PrimeAfter receiving an input prime signal, the machine will reset itself. This signal is onlyvalid when [Print Mode] is [ESC/P] or [HP-GL/2] mode.Note • Adobe Communication Protocol can be configured when the PostScript 3 Kit (optional) isinstalled.• Do not need to change the default settings for normal use. Some items may be required tobe changed depending on the operating system on the computer.5 Select [Close] repeatedly until the [System Settings] screen is displayed.6 Select [Exit].7 After the machine is restarted, print out a settings list to confirm that the parallel port isenabled.For information on how to print a settings list, refer to "Print Report/List" under "Chapter 13 MachineStatus" in the User Guide.8 Turn off the computer.9 Connect a parallel interface cable to the parallel interface on the computer.10 Restart the computer.Configuration on the ComputerThe following describes the configuration procedure for the computer.In order to print from the machine, the computer needs to have a print driver installed.For information on the driver installation procedure, refer to the manual contained in the CentreWareUtilities CD-ROM.