Xerox apeosport 550 I Network Administration Manual

Contents

Xerox apeosport 550 I Network Administration Manual Manual pdf 97 page image

Installation Procedure95E-mail112) Select [TCP/IP - Get IP Address] and then select [Change Settings].3) Select one from [DHCP], [BOOTP], [RARP], [DHCP/Autonet] or [Manual] and thenselect [Save]. If you select anything other than [Manual], proceed to Step 4.Note • When using a DHCP server, also configure the WINS (Windows Internet Name Service)server.4) Select [TCP/IP - IP Address] and select [Change Settings].5) Enter the IP address using the numeric keypad.Note • Enter address in the format “xxx.xxx.xxx.xxx”. The "xxx" should be a numeric value in therange from 0 to 255. However, 224 or 225.xxx.xxx.xxx and 127.xxx.xxx.xxx cannot be used.• When you make an entry mistake, press the (Clear) button and enter again.• When moving to the next value without entering all 3 digits, select [Next].6) Select [Save].7) Configure [TCP/IP - Subnet Mask] and [TCP/IP - Gateway Address] as the above.Note • Enter address in the format “xxx.xxx.xxx.xxx”. The "xxx" should be a numeric value in therange from 0 to 255. However, 224 or 225.xxx.xxx.xxx and 127.xxx.xxx.xxx cannot be used.• Specify the subnet mask by a combination of the numbers 0, 128, 192, 224, 240, 248, 252,254, and 255. However, you cannot use 0 between non-zero values.• If you do not set the gateway address, enter "0.0.0.0".4 Select [Close] repeatedly until the [System Settings] screen is displayed.5 Select [Exit].6 After the machine is restarted, print out a settings list to confirm that the ports areenabled and TCP/IP is configured.For information on how to print a settings list, refer to "Print Report/List" under "Chapter 13 MachineStatus" in the User Guide.Configuring E-mail EnvironmentThe following describes the configuration procedure to use the e-mail feature.Note • The configuration can also be performed using CentreWare Internet Services.For information on how to use CentreWare Internet Services, refer to "Using CentreWare InternetServices" (P.65).1 Display the [System Administrator Menu] screen.1) Press the button.2) Enter the user ID with the numeric keypad or a keyboard displayed by pressing[Keyboard], and select [Confirm].Note • The default user ID is “11111”. When using the Authentication feature, a password isrequired. The default password is “x-admin”.3) Select [System Settings].2 Set the E-mail address, host name, and domain name.1) Select [System Settings].2) Select [Network Settings].3) Select [Machine E-mail Address/Host Name].4) Select [E-mail Address] and then select [Change Settings].5) Enter an E-mail address using the keyboard displayed.6) Select [Save].7) Set a host name and a domain name as above.8) Select [Close].