Xerox apeosport 550 I Network Administration Manual

Contents

Xerox apeosport 550 I Network Administration Manual Manual pdf 57 page image

Installation Procedure55Installation When Using Microsoft Network (SMB)73 Set an IP address.If an IP address is already set, this step is not necessary. Also, in an environment withDHCP or BOOTP, configure the way to obtain an IP address. Either the addresscannot be obtained automatically or manual configuration is preferred, configure an IPaddress, a subnet mask, and a gateway address.1) Select [Protocol Settings].2) Select [TCP/IP - Get IP Address] and then select [Change Settings].3) Select one from [DHCP], [BOOTP], [RARP], [DHCP/Autonet] or [Manual] and thenselect [Save]. If you select anything other than [Manual], proceed to Step 4.Note • When using a DHCP server, also configure the WINS (Windows Internet Name Service)server.4) Select [TCP/IP - IP Address] and select [Change Settings].5) Enter the IP address using the numeric keypad.Note • Enter address in the format “xxx.xxx.xxx.xxx”. The "xxx" should be a numeric value in therange from 0 to 255. However, 224 or 225.xxx.xxx.xxx and 127.xxx.xxx.xxx cannot be used.• When you make an entry mistake, press the (Clear) button and enter again.• When you would like to move to the next value without entering all 3 digits, select [Next].6) Select [Save].7) Configure [TCP/IP - Subnet Mask] and [TCP/IP - Gateway Address] as the above.Note • Enter address in the format “xxx.xxx.xxx.xxx”. The "xxx" should be a numeric value in therange from 0 to 255. However, 224 or 225.xxx.xxx.xxx and 127.xxx.xxx.xxx cannot be used.• Specify the subnet mask by a combination of the numbers 0, 128, 192, 224, 240, 248, 252,254, and 255. However, you cannot use 0 between non-zero values.• If you do not want to set the gateway address, enter "0.0.0.0".4 Select [Close] repeatedly until the [System Settings] screen is displayed.5 Select [Exit].6 After the machine is restarted, print out a settings list to confirm that the SMB port isenabled and TCP/IP is configured.For information on how to print a settings list, refer to "Print Report/List" under "Chapter 13 MachineStatus" in the User Guide.Note • If using the NetBEUI protocol, select [NetBEUI] as the protocol used by SMB for the portconfiguration using CentreWare Internet Services.Configure other SMB settings as necessary. Refer to "SMB" (P.74) for the SMB configuration.Configuration on the ComputerThe following describes the configuration procedure for the computer.In order to print from the machine, the computer needs to have a print driver installed.For information on the supported operating systems, refer to "Supported Operating Systems" (P.19).For information on the driver installation procedure, refer to the manual contained in the CentreWareUtilities CD-ROM.