5.1 A: Initialization144 YASKAWA ELECTRIC SIEP C710616 27G YASKAWA AC Drive A1000 Technical ManualSetting 3330: 3-Wire InitializationThe drive parameters are returned to factory default values with digital inputs S1, S2, and S5 configured as Run, Stop,and Forward/Reverse respectively. Also refer to digital input functions, Setting 0: 3-Wire Sequence on page 236.Setting 5550: oPE04 ResetIf parameters on a certain drive have been edited and then a different terminal block is installed with different settingssaved in its built-in memory, an oPE04 error will appear on the display. To use the parameter settings saved to theterminal block memory, set A1-03 to 5550.Notes on Parameter InitializationThe parameters shown in Table 5.1 will not be reset when the drive is initialized by setting A1-03 = 2220 or 3330.Although the control mode in A1-02 is not reset when A1-03 is set to 2220 or 3330, it may change when an applicationpreset is selected.Table 5.1 Parameters not Changed by Drive Initialization A1-04, A1-05: Password and Password SettingA1-04 is for entering the password when the drive is locked. A1-05 is a hidden parameter used to set the password.How to use the PasswordThe user can set a password for the drive to restrict access. The password is set to A1-05 and must be entered to A1-04 tounlock parameter access. Until the correct password is entered, the following parameters cannot be viewed or edited:A1-01, A1-02, A1-03, A1-06, A1-07, and A2-01 through A2-32.The instructions below demonstrate how to set a new password. Here, the password set is “1234”. An explanationfollows on how to enter the password to unlock the parameters.Table 5.2 Setting the Password for Parameter LockNo. Parameter NameA1-00 Language SelectionA1-02 Control Method SelectionE1-03 V/f Pattern SelectionE5-01 Motor Code Selection (for PM motors)E5-02 Motor Rated Power (for PM Motor)E5-03 Motor Rated Current (for PM Motor)E5-04 Number of Motor Poles (for PM Motor)E5-05 Motor Stator Resistance (for PM Motor)E5-06 Motor d-Axis Inductance (for PM Motor)E5-07 Motor q-Axis Inductance (for PM Motor)E5-09 Motor Induction Voltage Constant 1 (for PM Motor)E5-24 Motor Induction Voltage Constant 2 (for PM Motor)F6-/F7- Communication parameter (initialized when F6-08 = 1)L8-35 Installation Selectiono2-04 Drive/kVA SelectionNo. Parameter Name Setting Range DefaultA1-04 Password 0000 to 9999 0000A1-05 Password SettingStep Display/Result1. Turn on the power to the drive. The initial display appears.2. Press the or key until the Parameter Setting Mode screen appears.- MODE -U1-01= 0.00HzU1-02= 0.00HzU1-03= 0.00ADRVFREF (OPR)RdyJOG FWD FWD/REVLSEQLREFHELP- MODE - PRGDATAProgrammingFWD
