3.6 Digital Operator and Front CoverYASKAWA ELECTRIC SIEP C710616 27G YASKAWA AC Drive A1000 Technical Manual 70Electrical Installation33.6 Digital Operator and Front CoverThe digital operator can be detached from the drive for remote operation, or when the front cover has to be opened toinstall an option card.NOTICE: Be sure the digital operator has been removed prior to opening the front cover or reattaching it. Leaving the digital operatorplugged into the drive when removing the front cover can result in erroneous operation caused by a poor connection. Beforereattaching the operator make sure the front cover has been firmly fastened back into place. Removing/Reattaching the Digital Operator Removing the Digital OperatorWhile pinching inwards on the hook located on the right side of the digital operator, pull forward and remove theoperator from the drive.Figure 3.14Figure 3.11 Removing the Digital Operator Reattaching the Digital OperatorInsert the digital operator into the opening in the front cover while aligning it with the notches on the left side of theopening. Next press gently on the right side of the operator until it clicks into place.Figure 3.15Figure 3.12 Reattaching the Digital Operator Removing/Reattaching the Front Cover Removing the Front Cover2A0004 to 2A0081 and 4A0002 to 4A0044After removing the terminal cover and the digital operator, loosen the screw that affixes the front cover (modelCIMR-A2A0056, 4A0031, 4A0038 do not use a screw to affix the front cover). Pinch inwards on hooks found on eachside of the front cover, then pull forward to remove it from the drive.Figure 3.16Figure 3.13 Remove the Front Cover (2A0004 to 2A0081 and 4A0002 to 4A0044)
