4.2 Using the Digital OperatorYASKAWA ELECTRIC SIEP C710616 27G YASKAWA AC Drive A1000 Technical Manual 99Start-Up Programming& Operation44.2 Using the Digital OperatorUse the digital operator to enter run and stop commands, display data, edit parameters, as well as display fault and alarminformation. Keys and DisplaysFigure 4.1Figure 4.1 Keys and Displays on the Digital OperatorNo.<1> The STOP key has highest priority. Pressing the STOP key will always cause the drive to stop the motor, even if a Run command is active atany external Run command source. To disable the STOP key priority, set parameter o2-06 to 0.<2> The LO/RE key can only switch between LOCAL and REMOTE when the drive is stopped. To disable the LO/RE key to prohibit switchingbetween LOCAL and REMOTE, set parameter o2-01 to 0.Display Name Function1 Function Key(F1, F2)The functions assigned to F1 and F2 vary depending on the menu that is currently displayed. The name of eachfunction appears in the lower half of the display window.2 ESC Key• Returns to the previous display.• Moves the cursor one space to the left.• Pressing and holding this button will return to the Frequency Reference display.3 RESET Key • Moves the cursor to the right.• Resets the drive to clear a fault situation.4 RUN KeyStarts the drive in the LOCAL mode.The Run LED• is on, when the drive is operating the motor.• flashes during deceleration to stop or when the frequency reference is 0.• flashes quickly the drive is disabled by a DI, the drive was stopped using a fast stop DI or a run commandwas active during power up.5 Up Arrow Key Scrolls up to display the next item, selects parameter numbers and increments setting values.6 Down Arrow Key Scrolls down to display the previous item, selects parameter numbers and decrements setting values.7 STOP Key <1> Stops drive operation.8 ENTER Key • Enters parameter values and settings.• Selects a menu item to move between displays.9 LO/RE Selection Key <2> Switches drive control and frequency setting between the operator (LOCAL) and an external source(REMOTE).10 RUN Light Lit while the drive is operating the motor. Refer to page 101 for details.11 LO/RE Light Lit while the operator is selected to run the drive (LOCAL mode). Refer to page 101 for details.12 ALM LED Light Refer to ALARM (ALM) LED Displays on page 101.LOREF2F1ESCRUN STOPENTERRESETALMDIGITAL OPERATOR JVOP-180 121198123104 5 6 7F1F2ESCRESETRUNSTOPENTERLORERUNLORE