5.6 F: Option Settings230 YASKAWA ELECTRIC SIEP C710616 27G YASKAWA AC Drive A1000 Technical Manual F4: Analog Monitor Card SettingsThese parameters set up the drive for operation with the analog output option card AO-A3. This section describesparameters that govern operation with an analog output option card. Refer to the instruction manual packaged with theoption card for specific details on installation, wiring, input signal level selection, and parameter setup. F4-01, F4-03: Terminal V1, V2 Monitor SelectionSelects the data to output from analog terminal V1. Enter the final three digits of U- to determine which monitordata is output from the option card. Some monitors are only available in certain control modes.Note: Set “000” or “031” when using the terminal in through mode. This setting can adjust the V1 and V2 terminal output from PLCvia MEMOBUS/Modbus communications or a communications option. F4-02, F4-04, F4-05, F4-06: Terminal V1, V2 Monitor Gain and BiasParameters F4-02 and F4-04 determine the gain, while parameters F4-05 and F4-06 set the bias. These parameters are setas a percentage of the output signal from V1 and V2 where 100% equals 10 V output. The terminal output voltage islimited to 10 V.Using Gain and Bias to Adjust Output Signal LevelThe output signal is adjustable while the drive is stopped.Terminal V11. View the value set to F4-02 (Terminal V1 Monitor Gain) on the digital operator. A voltage equal to 100% of theparameter being set in F4-01 will be output from terminal V1.2. Adjust F4-02 viewing the monitor connected to the terminal V1.3. View the value set to F4-05 on the digital operator, terminal V1 will output a voltage equal to 0% of the parameterbeing set in F4-01.Adjust F4-05 viewing the output signal on the terminal V1.Terminal V21. View the value set to F4-02 (Terminal V2 Monitor Gain) on the digital operator. A voltage equal to 100% of theparameter being viewed in F4-03 will be output from terminal V2.2. Adjust F4-04 viewing the monitor connected to the terminal V2.3. View the value set to F4-06 on the digital operator, terminal V2 will output a voltage equal to 0% of the parameterbeing set in F4-03.4. Adjust F4-06 viewing the output signal on the terminal V2. F4-07, F4-08: Terminal V1, V2 Signal LevelSets the output signal level for terminals V1 and V2.Setting 0: 0 to 10 VSetting 1: -10 to 10 VNo. Parameter Name Setting Range DefaultF4-01 Terminal V1 Monitor Selection 000 to 999 102F4-03 Terminal V2 Monitor Selection 000 to 999 103No. Parameter Name Setting Range DefaultF4-02 Terminal V1 Monitor Gain -999.9 to 999.9% 100.0%F4-04 Terminal V2 Monitor Gain -999.9 to 999.9% 50.0%F4-05 Terminal V1 Monitor Bias -999.9 to 999.9% 0.0%F4-06 Terminal V2 Monitor Bias -999.9 to 999.9% 0.0%No. Parameter Name Setting Range DefaultF4-07 Terminal V1 Signal Level 0, 1 0F4-08 Terminal V2 Signal Level 0, 1 0