2-15CABLE ROUTING DIAGRAM SPEC1 Ignition coil lead2 Clamp3 CDI magneto lead4 Neutral switch lead (except forUSA and CDN)5 Radiator breather hose6 Connector coverA Clamp the ignition coil lead tothe frame at its locating tape.Clamp it in front of the radiatorfitting boss.B Clamp the CDI magneto lead tothe frame at its locating tape.Clamp it at the rear of the radia-tor fitting boss.C Do not allow the neutral switchlead to slacken except over theradiator hose. (except for USAand CDN)D Pass the neutral switch leadthrough the holder. (except forUSA and CDN)E Pass the radiator breather hoseoutside the engine bracket andinside the down tube. Thenpass the radiator breather hoseinside the CDI magneto lead.F Clamp the CDI magneto lead,radiator breather hose, YPVSbreather hose and neutralswitch lead (except for USA andCDN) to the frame.G Clamp the radiator breatherhose, CDI magneto lead andneutral switch lead (except forUSA and CDN) to the frame.H Pass the CDI magneto lead,radiator breather hose and neu-tral switch lead (except for USAand CDN) in front of the radiatorhose. Then pass the radiatorbreather hose inside the CDImagneto lead and neutralswitch lead (except for USA andCDN).I Pass the radiator breather hoseand ignition coil lead betweenthe frame and the radiator (left).J Locate the clamp ends in thearrowed range.K Bring the connector cover intocontact with the coupler.
