AXIS 5570e/AXIS 5670e User’s Manual Section 7: Setting Up - NetWare 123Section 7 Setting Up - NetWareThis section describes how to continue the installation of the AXIS5570e/AXIS 5670e in the NetWare environment. Identify whichtransport protocol you are running on your network and whichinstallation method you should use. Continue the installation byselecting the appropriate installing instructions from the table below:See “NetWare Administration” on page 156. for information onNovell’s administration tools.If you intend to operate your AXIS 5570e/AXIS 5670e in a multi-protocol, mixed environment, you should also proceed to the otherrelevant sections in this manual.InstallationmethodTransportprotocol ActionNDPS TCP/IPIPX/SPXSee “Setup using NDPS” on page 124.- Public Access Printers, on page 124- Controlled Access Printers, on page 130iPrint iPrint over LPR See “Setup using iPrint” on page 143.andSee “Install a printer using AXIS LPRGateway Configuration Snapin” on page 146.iPrint over IPP See “Setup using iPrint” on page 143.andSee “Install a printer with AXIS IPP GatewayConfiguration Snapin” on page 145.Queue-basedprintingIPX/SPXBasicConfigurationTo install using the AXIS NetPilot InstallationWizard,See “Basic Setup with AXIS NetPilot” onpage 149..IPX/SPXAdvancedconfigurationIf you need a more advanced installationthat is not covered by the AXIS NetPilotInstallation Wizard,See “Advanced Installation using AXISNetPilot” on page 150..