Section 7: Setting Up - NetWare AXIS 5570e/AXIS 5670e User’s Manual124Setup using NDPSThe AXIS 5570e/AXIS 5670e supports Novell Distributed PrintServices (NDPS). You can run NDPS over Pure IP (TCP/IP) or IPX/SPX.Before the AXIS 5570e/AXIS 5670e can be installed, make sure thatNDPS is installed and a Broker is loaded on your NetWare file server.AXIS 5570e/AXIS 5670e uses the AXIS NDPS Gateway for printing innetworks using either IP or IPX as transport protocols. The printergateways are included with the NDPS software (from version 5.1 andup) and are automatically installed together with NDPS.Note:Installing the AXIS5570e/AXIS 5670e inthe NDPSenvironmentsHaving assigned an IP address to the AXIS 5570e/AXIS 5670e asdescribed in Assigning an IP Address to the Print Server, on page 14,you are now ready to install the AXIS 5570e/AXIS 5670e for NDPSprinting. You can select to install the connected printers as public orcontrolled access printers. Follow the instructions below to install theAXIS 5570e/AXIS 5670e using NDPS:Important:Public Access Printers Follow these instructions to create a public access printer using theNDPS Manager object in your NetWare administrator utility:NDPS requires that you run NetWare 4.11 or higher. Pure IP is only supported byNetWare 5 or higher.• The NDPS Enabled parameter of the AXIS 5570e/AXIS 5670e must be set toYes in order for the communication between the print server and the NDPSgateway to be enabled. To change this parameter, log in to the print server’sweb pages and choose: Admin => Network Settings=> Detailed View=>NetWare=> NDPS Enabled => Yes.• If you do not have an NDPS Manager object available, start out with creatingone in the NetWare Administrator.
