Section 21: Test Button AXIS 5570e/AXIS 5670e User’s Manual288Section 21 Test ButtonThe test button is located on the front right hand side of the AXIS5570e/AXIS 5670e and is used for:• Printing a test page, checking the connection to the printer.• Printing a parameter list, showing the AXIS 5570e/AXIS 5670ecurrent settings.• Resetting the AXIS 5570e/AXIS 5670e parameters to the factorydefault settings.The Test Page Press the test button once to print a test page. If the test page prints,the parallel interface is functioning correctly. The printed Test Pagecontains basic information about the AXIS 5570e/AXIS 5670e. It isrecommended that you print a test page every time you haveconnected the AXIS 5570e/AXIS 5670e to a printer.The Parameter List Press the test button twice to print a parameter list showing thecurrent AXIS 5570e/AXIS 5670e settings. This list providescomprehensive details of all the parameters and their current status.Refer to The Parameter List, on page 295.If you want to change any of the parameters, use one of the methodsthat are described in Management and Configuration, on page 180.Performing a FactoryDefaultFollow the instructions below to reset the AXIS 5570e/AXIS 5670e tothe factory default settings:1. Remove the external power supply to switch off the AXIS5570e/AXIS 5670e.2. Press and hold down the test button, while you reconnect theexternal power supply.3. Continue to hold down the test button until the networkindicator remains constantly lit. This should take about 20seconds.
