AXIS 5570e/AXIS 5670e User’s ManualSection 5: Setting Up - IBM Mainframe (zSeries) 95Defining theprinter to PSFEach AXIS 5570e/AXIS 5670e must be defined to PSF with aPRINTDEV statement in the PSF startup procedure. The followingkeywords are required on the PRINTDEV statement:• IPADDR='xxx.xxx.xxx.xxx'• PORTNO='xxxx'The IPADDR parameter specifies the IP address of the AXIS5570e/AXIS 5670e in dotted-decimal notation.Note:The PORTNO keyword specifies the TCP/IP port to use for the printsession. This port number must match the port number set up for theAXIS 5570e/AXIS 5670e in Configuring the AXIS 5570e/AXIS5670e, on page 71.Below is a sample procedure, APSWPROT, which you can modify to suityour installation. The PRINTDEV statement includes the requiredIPADDR and PORTNO keywords. In the PRINTDEV example below, theTCP/IP port number 5100 is used, but any port, larger that 1024, canbe used as long as the same port is set up in the AXIS 5570e/AXIS5670e.The APSWPROT procedure contains JCL parameters to produce astartup procedure for either 240-pel and 300-pel printers, but thereferences to 300-pel resolution are commented out. To createseparate startup procedures, make two copies of APSWPROT, and thenfollow the commented instructions in APSWPROT. Keep oneunchanged copy as your startup procedure for a resolution of 120 or240 pels. In the second copy, delete or comment out all references to240-pel resolution, and make all references to 300-pel resolutionactive. This changed copy is your startup procedure for 300-pelresolution.Do not specify a host name in place of the dotted-decimal address.
