Chapter 5 Paper Handling 5-13Paper HandlingPrinting on Fabric SheetsCanon Fabric Sheet FS-101 comes with a booklet that describes special handlingprocedures. Be sure to read this booklet for special information on fabric sheets.n• Do not use the fixing agent provided with the Canon Fabric Sheet FS-101. This agent isnot necessary when printing with your unit.• Do not touch newly printed fabric sheets until the ink has dried completely. This takesabout an hour.Follow this procedure to load a fabric sheet in the multi-purpose tray:1 Make sure the paper thickness lever isset to e (right).• For details, 1 p. 5-6.c Do not set the paper thickness leverwhile the unit is printing since thiswill cause problems.2 With the cloth side towards you andthe open end at the top, insert one fabricsheet into the multi-purpose tray q, andalign the right edge of the sheet with theright side of the multi-purpose tray. Slidethe paper guide snugly against the leftedge of the sheet w.3 Your unit is now ready to print. Set yourPC to print on the fabric sheet.4 When the fabric sheet is printed, let it dryfor about an hour to allow the ink to drycompletely.5 When dry, peel the film backing from theprinted fabric sheet.OPEN END ATTHE TOP 12InkCartridgeBCl-21ColorMade inJapanInkCartridgeBCl-21BlackMade inJapan
