Chapter 5 Paper Handling 5-15Paper Handling2 Raise both paper output guides.• You can hold the document tray up foreasy access to the paper output guides.*3 Make sure the paper thickness lever isset to e (right).• For details, 1 p. 5-6.c Do not set the paper thickness leverwhile the unit is printing since thiswill cause problems.4 Cut the banner paper along one of theperforations to the length required. Thengently fold along the perforationsbetween the first and second sheets.• Your banner can be up to six sheets(1782 mm) long.5 Place the banner paper behind the uniton a flat surface. Then insert the firstsheet into the multi-purpose tray q, andalign the right edge of the sheet with theright side of the multi-purpose tray. Slidethe paper guide against the left edge ofthe sheet, leaving a 1 mm gap betweenthe paper guide and the edge of thesheet w.• Make sure the sheet is under the tab on themulti-purpose tray.• Make sure the sheets behind the unit arealigned with the multi-purpose tray.TAB12InkCartridgeBCl-21ColorMade inJapanInkCartridgeBCl-21BlackMade inJapan* Australia and New Zealand only.
