COPYRIGHT © 2002 CANON INC. 2000 CANON iR1600/iR2000/iR1610/iR2010 SERIES REV.0 MAR. 2002 6 - 9CHAPTER 6 PICKUP/FEDING SYSTEM2.2.2 Pickup from the Multifeeder Traya. Movement of the Holding PlateWhile in standby, the holding plate is at the bottom supported by the cams mounted tothe front and rear of the manual feed pickup roller shaft.When the pickup roller rotates, the cams start to rotate in response, causing the holdingplate to move up so that the paper placed in the multifeeder comes into contact with thepickup roller.The separation pad is mounted opposite the pickup roller, serving to separate one sheetof paper and sending it to the inside of the machine.b. Multifeeder Tray Pickup Drive MechanismThe manual feed pickup roller rotates by the drive of the main motor reaching the gearof the manual feed tray pickup drive assembly. The timing at which paper is picked up iscontroller by the manual feed pickup solenoid drive signal (MFPD) from the DC control-ler PCB.As soon as the main motor starts to rotate, its drive is transmitted to the pickup drivetransmission gear.When the DC controller PCB generates the manual feed pickup solenoid drive signal(MFPD) and the solenoid goes ON as a result, the stopper will be released so that thepickup roller stops to rotate.
