CHAPTER 13 TROUBLESHOOTINGCOPYRIGHT © 2002 CANON INC. 2000 CANON iR1600/iR2000/iR1610/iR2010 SERIES REV.0 MAR. 2002 13-2016.3.4 Causes and Remedies for Service Error CodesThe causes and remedies for service error codes are as follows:##0100 [TX] The number allowed for retransmission of the procedure signal wasexceeded during transmissionThe transmission level is too low, and the other party cannot receive NSS, TSI,DCS, TCF, or the training signal correctly.Increase the transmission level so that the other party may receive the signal cor-rectly.After transmission of TCF immediately before the image signal, the other partymalfunctioned because of an echo.(1) Ask the operator of the other party to provide echo remedy 3.(2) Using a manual call, press the Start button after hearing the 1st DIS from theother party.(3) To prevent response to the 1st DIS from the other party, put a relatively longpause to the telephone number when registering an auto-dialing number.After transmission of the Q signal following the image signal, the line conditionbecame poor so that the other party cannot receive the image signal or the Q signalcorrectly.(1) Increase the transmission level so that the other party may service the imagesignal or the Q signal correctly.(2) crease the transmission start speed.(3) Adjust the NL equalizer so that the other party may receive the image signal orthe Q signal correctly.(4) Add an echo protect tone to the V.29 modem signal for transmission.(5) Increase the number of final flag sequences for the procedure signal so that theother party may receive the procedure signal correctly.Cause :Remedy :Cause :Remedy :Cause :Remedy :
