CHAPTER 13 TROUBLESHOOTINGCOPYRIGHT © 2002 CANON INC. 2000 CANON iR1600/iR2000/iR1610/iR2010 SERIES REV.0 MAR. 200213-114No.626364656667686970Functionwait time for reply from the server(SMTP transmission)wait time for reply from the server(SMTP transmission)wait time for reply from the server(POP reception)wait time for reply from the server(FTP transmission)communication time-out length(SMTP transmission)communication time-out length(SMTP reception)communication time-out length(POP transmission)communication time-out length(FTP transmission)number of text lines possible formail receptionRange of settings0 to 65535 sec0 to 65535 sec0 to 65535 sec0 to 65535 sec0 to 65535 min0 to 65535 min0 to 65535 min0 to 65535 min0 to 65535 linesInitial30030030030060606060300RemarksT05-504-03[No. 02. 03, 04]Use it to set conditions for RTN signal transmission. If an error occurs often when theRTN signal is transmitted at time of reception, increase the parameters to loosen the RTNsignal transmission conditions.MemoThe following error codes are associated with the transmission of the RTNsignal at time of reception:##104, ##107, ##114, ##201The RTN signal transmission condition (1) is the ratio of the number oferror lines in relation to the total number of lines per page of receptionimages.The RTN signal transmission condition (2) is the reference value *2 forburst errors *1 .The RTN signal transmission condition (3) is the number of errors notreaching the reference value for burst errors.*1: transmission errors spanning several lines.*2: If set to ‘15’, a transmission error spanning 5 consecutive lines isidentified as a burst error.If any of these conditions is detected while an image signal is being re-vised, the RTN signal will be transmitted after receiving the proceduresignal from the transmitting machine. A higher parameter will make thetransmission of the RTN signal more difficult.
