CHAPTER 13 TROUBLESHOOTINGCOPYRIGHT © 2002 CANON INC. 2000 CANON iR1600/iR2000/iR1610/iR2010 SERIES REV.0 MAR. 200213-212##0672 [TX] In V.34 transmission, the procedure fails to move from phase 2 tophase 3 and later, causing a T1 time-over condition##0674 [TX] In V.34 transmission, the procedure fails to move from phase 3 orphase 4 to a control channel or later, causing a T1 time-over condi-tionIn phase 3 or phase 4, the other party cannot receive the signal correctly, and discon-nect the line.(1) Increase the transmission level so that the other party may receive the signalcorrectly.(2) Prohibit the V.8/V.34 procedure.In phase 3 or phase 4, the signal from the other party cannot be received correctly.(1) Ask the operator of the other party to increase the transmission level so that thesignal may be received correctly.(2) Prohibit the V.8/V.34 procedure.Cause :Remedy :Cause :Remedy :Cause :Remedy :Cause :Remedy :##0673 [RX] In V.34 reception, the procedure fails to move from phase 2 tophase 3 and later, causing a T1 time-over conditionCause :Remedy :Cause :Remedy :In phase 2, the other party cannot receive the signal correctly, and disconnect theline.(1) Increase the transmission level so that the other party may receive the signalcorrectly.(2) Prohibit the V8./V.34 procedure.In phase 2, the signal from the other party cannot be received correctly.(1) Ask the operator of the other party to increase the transmission level so that thesignal may be received correctly.(2) Prohibit the V.8/V.34 procedure.In phase 2, the other party cannot receive the signal correctly, and disconnect theline.(1) Increase the transmission level so that the other party may receive the signalcorrectly.(2) Prohibit the V.8/V.34 procedure.In phase 2, the signal from the other party cannot be received correctly.(1) Ask the operator of the other party to increase the transmission level so that thesignal may be received correctly.(2) Prohibit the V.8/V.34 procedure.
