COPYRIGHT © 2000 CANON INC. 2000 2000 2000 2000 CANON iR5000/iR6000 REV.0 JULY 2000CHAPTER 5 SERVICE MODE5-74 TCOPIER>FUNCTIONUse it to check the operation of sensors.STCK-LMTUse it to adjust the position of the full sensor (PS104, PS105) of the shifttray.• If either of the full sensors (or both) detects paper, the machine will in-dicate‘ON’.• If neither of the sensors detects paper, the machine will indicate ‘OFF’.Caution • Use this mode when the full sensor has been replaced.• Be sure to move the sensors starting at the point farthest from the paper,moving them closer to the paper (in keeping with the characteristics ofthe sensors).Using the Mode1) Keep both sensors at the point farthest from the paper.2) Place a stack of sheets (about 60 mm high) at the point of detection ofeither sensor on the shift tray.3) Select the mode item, and press the OK key.4) By referring to the indication, move the sensor closer to the paper, andfix it in position where the indication changes to ‘ON’.5) Move the paper to the position of detection of the other sensor.6) Repeat step 4) for the other sensor.7) Press the Stop key to end the adjustment.Checking System-Related OperationsDOWNLOADUse it to switch to download mode of the system program.CautionUsing the Mode1) Turn off the machine and the PC.2) Disconnect the network-related cable connected to the machine.3) Connect the machine with the PC with a bi-Centronics cable.4) Turn on the PC.5) Turn on the machine.6) Select the mode item, and press the OK key.7) Start downloading using the service support tool.8) At the end of the operation, turn off and then on the main power switch.Download Free Service Manual at http://printer1.blogspot.com
