4 Operation4.8 LED indicators106 DS7 Soft starter 09/16 MN03901001Z-EN www.eaton.com4.8 LED indicatorsThe RUN and Error LEDs are used to indicate the DS7 soft starter’s operatingstate.The shades of gray below have the following meanings in the following table:= Green RUN LED= Red Error LEDStatus signal ViewOperationInitializationOff – No supply voltageSupply voltage without enable (EN), only in frame sizes 3 and 4 and all sizes in thecase of DS7-34D…-D soft startersSupply voltage and enable (EN), only in frame sizes 3 and 4 and all sizes in the caseof DS7-34D…-D BG4 soft startersRamp (t-Start or t-Stop)TOR (continuous operation)Current limitationConfiguration mode activatedRelays 23 and 24 configured as READYRelays 23 and 24 configured as RUNPhase sequence check enabledPhase sequence check disabledWarningOvertemperature after operation (A1 switched off)A1 start command without Enable (EN); only in sizes 3 and 4SmartWire-DT operation, potentiometer may be inoperative (DS7-34D… only)
