0 About this Manual0.1 List of revisionsDS7 Soft starter 09/16 MN03901001Z-EN www.eaton.com 50 About this ManualThis manual contains special information that you will need to connect a softstarter correctly and configure it to your requirements using the parameters.The details apply to the indicated hardware and software versions.The manual describes all construction sizes of the DS7 series soft starters.Differences and special characteristics of each rating level and constructionsize are listed accordingly.0.1 List of revisionsThe following significant amendments have been introduced since previousissues:0.2 Further manuals for this deviceFurther information can be found in the following manuals:On “Soft starter”• “Design of soft starters” - MN03902001Z-EN(previous description AWB8250-1346D)On “SmartWire-DT”• “SmartWire-DT The system” – MN05006002Z-EN(previous designation AWB2723-1617en)• “SmartWire-DT module” – MN05006001Z-EN(previous designation AWB2723-1613en)• “SmartWire-DT Gateways” – MN05013002Z-EN(previous designation AWB2723-1612en)• “XIOC signal modules” – MN05002002Z-EN(previous designation AWB2725-1452enPublication date Page Subject new modified deleted09/16 96 Extended functionality ✓44 Actuation of resistive loads ✓09/13 Fully revised; firmware version V46 ✓07/12 145ff. Chapter “SmartWire-DT” ✓All Complete revision ✓11/11 89 Size 2 (16 - 32 A) – Isolated relay contactsSize 3 and 4 (41 - 200 A) – Isolated relay contacts✓06/11 All Complete revision ✓ ✓04/11 56 Configuration options of DS7 ✓216 Power supply dependent data (further) ✓19 Power values ✓07/10 Initial issue
