3 Installation3.4 Electrical Installation82 DS7 Soft starter 09/16 MN03901001Z-EN www.eaton.com3.4.3 Connection to SmartWire-DTConnect the SWD external device plug with the adapted SmartWire-DTribbon cable.Figure 64: Connecting the SmartWire-DT external device plug with the adapted ribbon cable3.4.3.1 PKE32-COM communication cableTo connect a PKE motor-protective circuit-breaker (sizes 1 and 2 only) with aPKE-XTU(W)A-… trip block to a DS7-SWD soft starter (size 1 or size 2), youwill need a PKE32-COM communications cable. This cable will serve as acommunication link between the DS7-SWD soft starter and thePKE-XTU(W)A-… PKE trip block. Data will be exchanged via the PKE tripblock’s data interface and the data interface on the DS7-SWD soft starter.Figure 65: PKE32-COM communication cablea Connector for PKE-XTU(W)A-… trip blockb Data cable with connector for soft starter DS7-SWDNOTICEDo not install or remove the SWD4-8SF2-5 SmartWire-DTexternal device plug without switching off the supply and controlvoltages first.12SWD4-8SF2-5+ 15VSWD4-8SF2-5+ 15VSWD4-8SF2-5SWD4-100LF8-24SWD4-3LF8-24-2SSWD4-5LF8-24-2SSWD4-10LF8-24-2S①②
