1 Device series DS71.4 Description14 DS7 Soft starter 09/16 MN03901001Z-EN www.eaton.com1.4.2 DS7-34D…The following drawing shows a DS7-34D… soft starter with a SmartWire-DTconnection (hereafter referred to with the abbreviation DS7-SWD) of size 2.Figure 4: Description of the DS7-34D…-D soft startera Fixing holes (screw fastening)b Data interface for PKE32-COMc Cutout for mounting on mounting rail (DIN EN 50022-35)d Device fan (mounting space on rear)e Connection terminals of the power section, motor connection (2T1, 4T2, 6T3)f Control signal terminalsg Potentiometer (U-Start, t-Start, t-Stop)h Light-emitting diodes (RUN, Error): DS7 diagnostic LEDsi 1-0-A switchj Connection for SmartWire-DT external device plugk LED: SmartWire-DT diagnostic LEDl Connection terminals of the power section, mains voltage (1L1, 3L2, 3L3)￫ The SmartWire-DT external device plug with an adaptedSmartWire-DT ribbon cable is connected to the DS7-SWD softstarter via connection ⑩.For detailed instructions on how to use the SmartWire-DTexternal device plug (SWD4-8SF2-5) with the 8-pin SmartWire-DTcable, refer to the “Setting up SWD4-8SF2-5 external deviceplugs” section in manual MN05006002Z-EN,“SmartWire-DT - The System.”￫ SmartWire-DT diagnostic LED ⑪ shows the communicationstatus, the status of the DS7-SWD soft starter, and theswitching command via the SmartWire-DT system.For more information on the SmartWire-DT diagnostic LED,refer to ￫ section 8.10.4, “SmartWire-DT diagnostic LEDs”,page 214.①②④⑤⑥⑦⑧⑫③⑨⑩⑪
