GE MAC 2000 Operator's Manual

Also see for MAC 2000: Operator's manual Service manual Reference guide

7. Type a name for the new protocol and press OK.The Protocol window opens with all the stages from the template. You can now add, edit, or deletestages.8. To add a stage, do the following:a. Select the stage that precedes the new stage.b. Press Add Stage.The selected stage is duplicated.c. Edit the duplicate stage as appropriate.See step 9.9. To edit a stage, do the following:a. Select the stage to edit.b. Press Edit.The Edit Stage window opens.c. Modify the stage parameters as appropriate.Refer to the table preceding these instructions for a description of each parameter.d. When you are done, press OK.The Edit Stage window closes.10. To delete a stage, do the following:a. Select the stage you want to delete.b. Press Delete Stage.The selected stage is deleted.11. To remove custom Master’s Step stages, press Factory Defaults.NOTEReset treadmills and ergometers to factory defaults at the protocol level. See step 15.12. Repeat steps 8 through 10 as necessary.13. To rename the protocol, do the following:a. Press Edit Name.The Edit Name window opens.NOTEThis option is not available when editing a Master Step protocol.b. Change the name as appropriate.c. Press OK.The protocol’s name is changed.14. When you are done with the stages, press Save.This saves your changes and returns you to the previous window.15. To remove custom protocols, press Factory Defaults.Operator Manual 12.4 Stress ECG Setup2053535-002 Revision T MAC 2000 ECG Analysis System 126/198