6 - WPT PAGES127Airport ArrivalsWith the “RUNWAY” field highlighted, turnthe small right knob to select the desiredrunway. Many arrivals apply to all runways fora particular airport, as indicated by “ALL”.NOTE: “ALL” may appear in the runway field, indicat-ing the arrival procedure applies to all runways. Forairports with parallel runways, “B” may appear at theend of the runway designation to indicate the arrivalprocedure applies to both runways.8. Press ENT. To remove the flashing cursor, pressthe small right knob.Airport Arrival Page OptionsThe following option is available for the AirportArrival Page, by pressing the MENU key:Load into Active FPL? allows you to load theselected arrival into the active flight plan. This isidentical to loading an arrival procedure from theProcedures Page.To load an arrival procedure from the AirportArrival Page:1. Select the desired arrival, transition and runwayusing the steps above.2. Press MENU to display the Airport Arrival PageOptions.From the Airport Arrival Page, press MENUto display an options list. “Load into ActiveFPL?” allows you to add the arrival procedureto your flight plan for later use.3. Press ENT to select the “Load into Active FPL?”option.4. The Active Flight Plan Page appears. Press FPLto return to the Airport Arrival Page.NOTE: Loading an arrival procedure into the activeflight plan does NOT automatically alter the activeflight plan leg or direct-to navigation. Once loaded, thearrival is simply placed at the end of the flight plan. Tomanually transition to a loaded arrival, please see theprocedure below (an alternative method would be toremove the first occurrence of the destination airportidentifier).Select Next FPL Apt?As described earlier in this section.Select Destination Apt?As described earlier in this section.