12 - MESSAGESABBREVIATIONS &NAV TERMS197VLOC remote transfer key is stuck — (GNS 530Wonly) The remote VLOC transfer switch is stuck in theenabled (or “pressed”) state. Try pressing the switch againto cycle its operation. If the message persists, contact yourGarmin dealer for assistance.VLOC transfer key stuck — (GNS 530W only) TheVLOC flip-flop key is stuck in the enabled (or “pressed”)state. Try pressing the VLOC flip-flop key again to cycleits operation. If the message persists, contact your Garmindealer for assistance.Waypoint already exists — The name you have enteredfor a user waypoint already exists in memory.Waypoint(s) have been replaced — One or more userwaypoints were updated during a unit-to-unit crossfilloperation.Waypoint memory is full — You have used all 1000 userwaypoint locations in the 500W-series unit memory. Deleteunwanted waypoints to make room for new entries.Turn Advisory and Arrival AnnunciationsThe following annunciator messages may appear in thelower right corner of the 500W-series unit display:Arriving at waypoint — Arriving at the destinationwaypoint for the active leg.Hold direct — “Direct” holding pattern entry.Hold parallel — “Parallel” holding pattern entry.Hold teardrop — “Teardrop” holding pattern entry.Left to xxx° in xx sec — Turn advisory. Turn to the indi-cated heading by the time shown.Left to xxx° now — Turn advisory. Turn to the indicatedheading by the time shown.Next DTK xxx° in xx sec — Waypoint alert. Prepare toturn to the indicated heading upon waypoint passage.PTK end in xx sec — Parallel Offset is terminating.Right to xxx° in xx sec — Turn advisory. Turn to theindicated heading by the time shown.Right to xxx° now — Turn advisory. Turn to the indicatedheading by the time shown.
