3 - DIRECT-TO63Cancelling / Manual CourseCancelling Direct-To NavigationOnce a direct-to is activated, the 500W-series unitprovides navigation guidance to the selected destina-tion until the direct-to is either replaced with a newdirect-to or flight plan, or cancelled, or if the unit isturned off.To cancel a direct-to, select a new direct-todestination, activate a flight plan or selectthe “Cancel Direct-To NAV?” option.To cancel a direct-to:1. Press the direct-to key to display the SelectDirect-to Waypoint Page.2. Press MENU to display the Direct-to Optionsmenu.3. With “Cancel Direct-To NAV?” highlighted,press ENT. If a flight plan is still active, the500W-series unit resumes navigating the flightplan along the closest leg.Specifying a Course to a WaypointWhen you perform a direct-to, the 500W-seriesunit sets a direct geodetic course to your selecteddestination. You can also manually define the course toyour destination, using the course field (“CRS”) on theSelect Direct-to Waypoint Page.The “CRS” field allows you to define thecourse to a direct-to destination waypoint.Use the small and large right knobs to enterthe desired course.To manually define the direct-to course:1. Press the direct-to key.2. Use the small and large right knobs to selectthe destination waypoint.3. Press ENT to confirm the selected waypoint,then turn the large right knob to highlightthe course (“CRS”) field.4. Turn the small and large right knobs to selectthe desired course and press ENT.5. Press ENT again to begin navigation using theselected destination and course.6. To reselect a direct course from present posi-tion (or select a new manually-defined course),simply press direct-to, followed by ENTtwice.