Configuring (Replacing)1. Remove the disk drive from its protective packaging, and open the drive latchhandle.2. Install the disk drive in the drive slot. Align the disk drive with the drive slot rails,and slide the disk drive into the slot until it contacts the backplane at the rear ofthe drive bay. The drive should be in far enough for the latch handle to engage thelatch. Push the disk drive lever up and to the rear to lock the disk drive. The LEDabove the slot will turn on.3. Log in as root user.4. At the command line, type smitty.5. Select Devices.6. Select Install/Configure Devices Added After IPL and press Enter. Successfulconfiguration is indicated by the OK message displayed next to the Command fieldat the top of the screen7. Press F3s, Cancel, to go back to the first menu and select System StorageManagement (Physical and Logical Storage) and press Enter.8. Select Logical Volume Manager and press Enter.9. Select Volume Groups and press Enter.10. Select Set Characteristics of a Volume Group and press Enter.11. Select Add a Physical Volume to a Volume Group.12. Fill in the fields for the drive you are adding to the system. Press F4 for a list ofselections.13. See theAIX System Management Guide: Operating System and Devices to finishthe drive configuration. This publication is available at the following Web address:http://www.ibm.com/systems/aix/library/. Select Technical Publications. Thispublication is also contained on theAIX Documentation CD. The documentation ismade accessible by loading the documentation CD files onto the hard disk or bymounting the CD in the CD-ROM drive.14. Press F10 to exit smitty.298 Service Guide
