Testing the SetupThis section contains sample testing procedures to help ensure that your setup isworking.These tests include communicating with the server operating system. Before you start,ensure that the necessary serial port(s) is configured. If you need assistance, refer to“Serial Port Configuration” on page 323.The server should be powered off as a result of the “Service Processor SetupChecklist” on page 321.Testing Call-In1. At your remote terminal, call in to your server. Your server answers and offers youthe Service Processor Main Menu after requesting your privileged access password.2. Select System Power Control.3. Select Power-On System.When you are asked if you wish to continue powering on the system, type Y.4. After the system firmware and operating system have initialized the server, the loginprompt displays at your remote terminal if you set up Seamless Modem Transfer(refer to “Transfer of a Modem Session” on page 331 for more information). Thismay take several minutes. When the login prompt displays, you have successfullycalled the service processor.5. Type logout to disconnect from the operating system. The message No Carrierdisplays on your remote terminal.6. Call your server again. The operating system answers and offers you the loginprompt. If these tests are successful, call-in is working.7. Log in and type shutdown to shut down your server.8. The message No Carrier displays on your remote terminal.Testing Call-OutDuring the setup, you entered your phone numbers for the pager (on page 203) andcustomer voice (on page 203). These numbers are used for this test.1. Your remote terminal is disconnected as a result of the Call-In test.2. Call your server again.3. At the service processor main menu, select Call-In/Call-Out Setup menu, thenselect Call-Out test. This action causes a simulated error condition for the purposesof this test.4. After a few moments, a message displays, regarding an illegal entry. Press Enter toclear the message and return to the main menu.5. When your telephone rings, answer the call. You should hear the sound of atelephone being dialed. Your computer is trying to page you.If this test is successful, call-out is working correctly.322 Service Guide
