MAP 1240: Memory Problem ResolutionNote: The firmware checkpoint that sent you here could be one of the following: E122,E213, E214, E218, E220 or E3xx. You may also have been sent here by an8-digit error code.Purpose of This MAPThis MAP is used to troubleshoot a problem during the memory test when the systemstops at a memory checkpoint and/or a error code is displayed on the operator panel.Notes:1. If the symptom changes while you are using this MAP, check for loose cards,cables, and obvious problems. If you do not find a problem, go to “MAP 1540:Minimum Configuration” on page 63.2. The service processor may have recorded one or more symptoms in its error log. Itis a good idea to examine that error log before proceeding (see Service ProcessorSystem Information Menu). If you find an obvious problem, fix the problem; then goto ″MAP 0410: Repair Checkout″ in theRS/6000 EserverpSeries DiagnosticInformation for Multiple Bus Systems.3. The service processor may have been set by the user to monitor service operationsand to attempt recoveries. You might want to disable these actions while youdiagnose and service the system. If you disable them, make notes of their currentsettings so that you can restore them before you leave. The following settings maybe of interest to you.Surveillance From the Service Processor Setup Menu, go tothe Surveillance Setup Menu and disablesurveillance.Unattended Start From the Service Processor System PowerControl Menu, disable unattended start mode.Reboot Policy From the System Power Control Menu, go tothe Reboot/Restart Policy Setup Menu and set:1. Number of reboot attempts to 0 (zero)2. Use OS-Defined restart policy to No3. Enable supplemental restart policy to No.Call Out From the Call-In/Call-Out Setup Menu, go tothe Serial Port Selection Menu and disablecall-out on both serial ports.Chapter 3. Maintenance Analysis Procedures (MAPs) 49
