# responses.expect "8\r" or "7\r" or "6\r" or "4\r" or "3\r"delay 2doneSample File modem_f0.cfg## COMPONENT_NAME: (ESPSETUP) ENTRY SERVICE PROCESSOR SETUP F0## FUNCTIONS: Modem configuration file for many recent Hayes* compatible modems.# This example uses the AT&F0 reset command to choose the factory defaults.# This set up is preferred for modems with extended (&) commands. For early# vintage modems, setup Z or Z0 is recommended. If your modem responds to# the extended (&) commands and to factory default choices (&Fn), but doesn’t# work properly with this setup file, setup F1 is recommended.## * Trademark of Hayes Microcomputer Products, Inc.## (C) COPYRIGHT International Business Machines Corp. 1996# All Rights Reserved# Licensed Materials - Property of IBM## US Government Users Restricted Rights - Use, duplication or# disclosure restricted by GSA ADP Schedule Contract with IBM Corp.### If the modem has configuration switches, they should be set to the# factory default settings.ICDelay 1DefaultTO 10CallDelay 120# AT Attention Code , Inserts delay in dialing commands# &F0 Reset. Restore profile 0 Q0 Turn on responses# E0 Turn echo off Q1 Turn off responses# V0 Use numeric responses S0=0 Automatic answer inhibit# +++ Escape to command mode S0=2 Answer on second ring# H0 Hang-up X0=0 Limit modem response codes# T = Tone mode. When used as T\r, it is a# no op to maintain program synchronization# when modem may/will echo the commands.## &C1 Detect CD &D2 Respond to DTR (often the default)# &R1 Ignore RTS (CTS)## %N Call-Out phone number %P Paging phone number# %S Modem speed (available to users)## Following are common responses from a wide range of modems:# 16, 15, 12, 10, 5 and 1 are connection responses. Add others as required.# 7=busy; 6=no dial tone; 4=error; 3=no carrier; 2=ring; 0=OK## PROGRAMMING NOTE: No blanks between double quote marks (").condout: send "AT&F0Q0T\r" # Reset modem. Select profile 0ignore "0\r" or "OK\r\n" timeout 2 # Ignore modem response.send "ATE0T\r" # Initialize modem: Echo OFF,expect "0\r" or "OK\r\n" timeout 2 # Enable responses (Numeric),send "ATQ0V0X0T\r" # Limit response codes.expect "0\r" timeout 2 # Confirm commands successful.send "ATS0=0\r" # Set AutoAnswer OFFexpect "0\r" timeout 2 # Confirm command successful.send "AT&C1&D2&R1\r" # Detect carrier and DTR,# Ignore RTS.expect "0\r" timeout 2 # Confirm command successful.doneAppendix D. Modem Configurations 343
