Icom IC-7100 Advanced Instructions

Also see for IC-7100: Finger touch operation Specification Basic Manual Service manual Instruction manual

Contents

Icom IC-7100 Advanced Instructions Manual pdf 321 page image

17 SET MODE17-18Monitor (Default: OFF)Function > Monitor (Monitor)Turn the monitor function ON or OFF.This function allows you to monitor your transmit signalin any mode other than CW.• OFF: Turns the function OFF.• ON: Monitors your transmit signal.Monitor Level (Default: 50%)Function > Monitor Level (Monitor Level)Adjust a transmit signal monitor level number between0% (no audio), 1% (minimum) and 100% (maximum)for the voice synthesizer.Beep Level (Default: 50%)Function > Beep Level (Beep Level)Adjust the confirmation and band edge beep tones out-put level to between 0% (no beep), 1% (minimum) and100% (maximum).Beep Level Limit (Default: ON)Function > Beep Level Limit (Beep Level Limit)Turn the confirmation and band edge beep tones out-put level limiting ON or OFF.When you set this item to ON, the beep tones areadjusted by the [AF] control until rotating the controlreaches to the specified level. Further rotation will notincrease the volume of the beep tones.• OFF: Beep level adjustment is not limited.• ON: Beep level adjustment is limited with the [AF]control.Beep (Confirmation) (Default: ON)Function > Beep (Confirmation) (Beep (Confirmation))Turn the confirmation beep ON or OFF.Set the beep output level in the “Beep Level” item asdescribed above.• OFF: The confirmation beep is OFF. (Silent opera-tion)• ON: The confirmation beep sounds each time aswitch is pushed.Band Edge Beep (Default: ON (Default))Function > Band Edge Beep (Band Edge Beep)When you tune into or out of an amateur band’s fre-quency range, you can hear a beep tone.If you select “ON (User)” or “ON (User) & TX Limit,” youcan program a total of 30 band edge frequencies in the“User band Edge” item.You can set the beep output level in the “Beep Level”item as described to the left.• OFF: Band edge beep is OFF• ON (Default): When you tune into or out of the de-fault amateur band’s frequency range,a beep sounds.• ON (User): When you tune into or out of a user pro-grammed amateur band’s frequencyrange, a beep sounds.• ON (User) & TX Limit:When you tune into or out of a user pro-grammed amateur band’s frequencyrange, a beep sounds.In addition, transmission is inhibitedoutside the programmed range.User Band EdgeFunction > User Band Edge (User Band Edge)This “User Band Edge” item appears only when “ON(User)” or “ON (User) & TX Limit” is selected in the“Band Edge Beep” item.When you select “ON (User)” or “ON (User) & TX Limit”in the “Band Edge Beep” item, you can program a totalof 30 band edge frequencies in this item.See page 3-14 for programming details.RF/SQL Control (Default: RF+SQL)Function > RF/SQL Control (RF/SQL Control)Set the [RF/SQL] control operation.• AUTO: [RF/SQL] functions as only an RF gain con-trol in SSB, CW and RTTY; a squelch con-trol in AM, FM, WFM and DV.• SQL: [RF/SQL] functions as a squelch control.• RF+SQL: [RF/SQL] functions not only as an RF gaincontrol, but also as a squelch control in allmodes.Function Set mode