4 RECEIVE AND TRANSMIT4-4Operating CW (Continued)D About the CW reverse modeThe CW reverse mode receives signals with a reverseside CW carrier point similar to voice LSB and USBmodes.Use when interfering signals are near a desired signaland you want to reduce the interfering tone.On the Mode selection screen, touch “CW” to selectqthe CW mode.After the CW mode is selected, touch “CW” again onwthe Mode selection screen to toggle between CWand CW-R modes.• Check that the interfering tone can be reduced.D About keying speedThe transceiver’s internal electronic keyer speed canbe adjusted to between 6 and 48 wpm (words per min-ute) .Pushq SPEED/PITCH (C) to open the Key speed/CW pitchadjustment display.Rotate [M-CH]w (L) clockwise to increase keyingspeed; counterclockwise to decrease it.Pushe MENU (C) to close the display.D About CW pitch controlThe received CW audio pitch can be adjusted to suityour preference without changing the operating fre-quency.Pushq SPEED/PITCH (C) to open the Key speed/CW pitchadjustment display.Rotate [BANK]w (L) to suit your preference.• Adjustable from 300 to 900 Hz (in 5 Hz steps).Pushe MENU (C) to close the display.Key speed adjustmentCW pitch adjustmentCarrier pointThe CW carrier point is set to the LSB side by de-fault, the setting can be changed to USB side in the“CW Normal Side” item of the “Function” Set mode.(p. 17-21)SET (C) > Function > CW Normal SideLeft RightCenterDisplayBFOCW-R mode (USB side)BFODesired signalCW mode (LSB side)Interference Desired signalInterferenceThe L, R, C or D in theinstructions indicate thepart of the controller.L: Left sideR: Right sideC: Center bottomD: Display (Touch screen)
