17 SET MODE17-22MIC AF Out (Default: OFF)Function > MIC AF Out (MIC AF Out)Select the [MIC] connector output function.• OFF: The [MIC] connector does not output the re-ceived audio.When using the optional HM-151 remote con-trol mic, select “OFF.”• ON: The [MIC] connector outputs the received au-dio.When using a speaker microphone or headset,select “OFF.”[F-1] (Default: SPLIT)Function > RC MIC > [F-1] ([F-1])The function listed below can be assigned to [F-1] onthe optional HM-151 remote control mic.• --(No function), P.AMP/ATT, AGC, NB, NR, NOTCH,RIT, AUTOTUNE/RX>CS, TS, MPAD, M-CLR, BANK,SPLIT, A/B, DUP, TONE/DSQL, COMP, TBW, METER,DR, FROM/TO (DR), SCAN, Voice TX (T1)[F-2] (Default: A/B)Function > RC MIC > [F-2] ([F-2])The function listed below can be assigned to [F-2] onthe optional HM-151 remote control mic.• --(No function), P.AMP/ATT, AGC, NB, NR, NOTCH,RIT, AUTOTUNE/RX>CS, TS, MPAD, M-CLR, BANK,SPLIT, A/B, DUP, TONE/DSQL, COMP, TBW, METER,DR, FROM/TO (DR), SCAN, Voice TX (T1)Mode Select (Default: All mode)Function > RC MIC > Mode Select (Mode Select)Disables the mode selection with the optional HM-151remote control mic, to simplify operation.• SSB, CW, RTTY, AM, FM, WFM, DVPower OFF (With No Controller) (Default: ON)Function > Power OFF (With No Controller) (PowerOFF (With No Controller))Select to automatically turn OFF the transceiver whenthe controller is disconnected from the transceiver.• OFF: The transceiver power is ON.• ON: The transceiver is automatically turned OFF.REF AdjustFunction > REF Adjust (REF Adjust)During frequency calibration, set the internal referencefrequency to between 0% and 100% range.NOTE:The default setting is different for each transceiver.Function Set mode (Continued)
