3 BASIC OPERATION3-14Setting frequency (Continued)D Programming the user band edgeWhen “ON (User)” or “ON (User) & TX Limit” is selectedin the “Band Edge Beep” item, the “User Band Edge”item appears in the “Function” Set mode.A total of 30 band edge frequencies can be programmedin the “User Band Edge” item.NOTE:• All frequency ranges are set to default, so youshould delete or change them to add the desiredband edge frequency.• Program each channel from left to right and eachfrequency must be higher than the preceding fre-quency.• The frequency that is duplicated, or out of a trans-mit frequency range, cannot be programmed.Pushq SET (C) to enter the Set mode.Touch the “Band Edge Beep” item of the “Function”wSet mode.Function > Band Edge Beep• If the specified item is not displayed, touch [Y] or [Z](D)one or more times to select the page.Touch the “ON (USER)” or “ON (User) & TX Limit”eoption.Touch the “User Band Edge” item of the “Function”rSet mode.Function > User Band EdgeFollow the instructions in the next topics to delete,tinsert, edit, change or reset Band edges.After you have finished, pushy SET (C) to exit the Setmode.• Deleting a Band edgeEnter the “User Band Edge” screen.qSET (C) > Function > User Band EdgeTouch for 1 second the Band edge to be deletedw .• If the specified band edge is not displayed, touch [Y] or[Z](D) one or more times to select the page.Touch “Delete.”e• The selected Band edge has been deleted, and then re-turns to the User Band Edge screen.Touch [r ](D) or push MENU (C) to return to the“Function” Set screen.The L, R, C or D in the instructions indicate thepart of the controller.L: Left side, R: Right side, C: Center bottomD: Display (Touch screen)Touch“Function”Push SETTouch “UserBand Edge”Touch for 1 sec-ond the Bandedge to be de-letedTouch “Delete”Example: Deletes the 1.800–1.999999 MHz range
