Steps 393Use the applicable show commands on the router to verify thatDHCP relay has been activated to reach the correct scope foreach VLAN.--End--Configure the Ethernet Routing Switch 8300The configuration procedure is based on the following assumptions:• You are starting with an installed switch that is not currently configuredas part of the network.• You have installed Software Release 2.2.8.• You have configured basic switch connectivity.• You have initialized the switch and it is ready to accept configuration.• You have configured devices as described to this point.StepsTo configure the Ethernet Routing Switch 8300for the Nortel SNASnetwork, perform the following steps:1. “Enabling SSH” (page 393)2. “Configuring the Nortel SNAS pVIP subnet” (page 394)3. “Creating port-based VLANs” (page 394)4. “Configuring the VoIP VLANs” (page 394)5. “Configuring the Red, Yellow, and Green VLANs” (page 394)6. “Configuring the NSNA uplink filter” (page 394)7. “Configuring the NSNA ports” (page 394)8. “Enabling NSNA globally” (page 395)Enabling SSHPassport-8310:5# config bootconfig flags ssh truePassport-8310:5# config sys set ssh enable truePassport-8310:5# config load-module 3DES /flash/P83C2280.IMGATTENTIONYou have the option of using the AES encryption module, instead of the 3DESmodule.Nortel Secure Network Access SwitchUsing the Command Line InterfaceNN47230-100 03.01 Standard28 July 2008Copyright © 2007, 2008 Nortel Networks.
