58 Managing the network access devices• Create the domain, if applicable. If you ran the quick setup wizardduring initial setup, Domain 1 is created. For more information aboutcreating a domain, see “Configuring the domain” (page 79).• Configure the edge switches for Nortel SNAS (see “Nortel SNASconfiguration roadmap” (page 37), step 4). For detailed informationabout configuring the edge switches for Nortel SNAS, see ReleaseNotes for the Ethernet Routing Switch 8300, Software Release 2.2.8, or Release Notes for Nortel Ethernet Routing Switch 5500 Series,Software Release 5.0.1, .For secure communication between the Nortel SNAS and the networkaccess devices, each must have knowledge of the other’s public SSH key.After you have added the network access devices to the Nortel SNASdomain, you must exchange the necessary SSH keys (see “ManagingSSH keys” (page 68)).You require the following information for each network access devices:• IP address of the switch• VLAN names and VLAN IDs for the Red, Yellow, and Green VLANs• the TCP port to be used for Nortel SNAS communication• for Ethernet Routing Switch 8300 switches, a valid rwa user nameManaging network access devicesThe Nortel SNAS starts communicating with the network access devicesas soon as you enable the switch on the Nortel SNAS by using the/cfg/domain #/switch #/ena command.You cannot configure the VLAN mappings for a network access devices inthe Nortel SNAS domain if the switch is enabled. When you add a networkaccess devices to the domain, it is disabled by default. Do not enable thenetwork access devices until you have completed the configuration. Toreconfigure the VLAN mappings for an existing network access devices,first disable it by using the /cfg/domain #/switch #/dis command.Roadmap of domain switch commandsThe following roadmap lists the CLI commands to configure the networkaccess devices in a Nortel SNAS deployment. Use this list as a quickreference or click on any entry for more information:Command Parameter/cfg/domain #/switch /cfg/domain #/switch #/deleteNortel Secure Network Access SwitchUsing the Command Line InterfaceNN47230-100 03.01 Standard28 July 2008Copyright © 2007, 2008 Nortel Networks.
