Steps 397Add the client ports:5510-48T(config)# interface fastEthernet 3-55510-48T(config-if)# nsna dynamic voip-vlans 2405510-48T(config-if)# exitEnabling NSNA globally5510-48T(config)# nsna enableConfigure the Nortel SNASTo configure the Nortel SNAS, perform the following steps:1. “Performing initial setup” (page 397)2. “Completing initial setup” (page 398)3. “Adding the network access devices ” (page 399)4. “Mapping the VLANs” (page 401)5. “Enabling the network access devices ” (page 401)Performing initial setupEstablish a serial console connection to the Nortel SNAS device. TheSetup utility launches automatically on startup.Alteon iSD NSNASHardware platform: 4050Software version: x.x-------------------------------------------------------[Setup Menu]join - Join an existing clusternew - Initialize host as a new installationboot - Boot menuinfo - Information menuexit - Exit [global command, always available]>> Setup# newSetup will guide you through the initial configuration.Enter port number for the management interface [1-4]: 1Enter IP address for this machine (on managementinterface): 10.40.40.2Enter network mask [255.255.255.0]: Enter VLAN tag id (or zero for no VLAN) [0]:Enter default gateway IP address (or blank to skip):10.40.40.1Enter the Management IP (MIP) address: 10.40.40.3Nortel Secure Network Access SwitchUsing the Command Line InterfaceNN47230-100 03.01 Standard28 July 2008Copyright © 2007, 2008 Nortel Networks.
